9.2
really awful- Typical Repair Cost:
- $3,000
- Average Mileage:
- 79,450 miles
- Total Complaints:
- 5 complaints
Most common solutions:
- not sure (3 reports)
- deactivation of 2 cylinder (1 reports)
- fix spark wires that came loose from coil pack (1 reports)
This problem may be covered under warranty. Ask your GMC dealer.
My truck started misfiring one morning, I changed spark plugs, wires, and coils, and that didn't solve the problem. I had it transported to Goodyear, but they could not solve the problem, they advertised take it to the dealership. I had it transported to the dealership, and I was told by the dealership I needed a new engine. I knew better than that, so I had it transported back to my house, and I did a compression test on # 2 cylinder 0 psi on the cylinder. I knew the problem, the valve spring collapsed, then had to have it pulled and taken to machine shop to be redone. I did all the work, I think there was a lawsuit for deactivating cylinder.
- diamonddave1065dw, Saucier, US
I WAS JUST DRIVING DOWN THE ROAD PULLING MY BOAT TO THE LAKE AND THE TRUCK STARTED MISFIRING AND WENT INTO LIMP MODE. I CALLED THE DEALERSHIP AND LIMPED IT THERE. OF COURSE THIS WAS CUTTING INTO MY TIME AT THE LAKE. WHEN AT THE DEALERSHIP THEY TOOK IT INTO THE SHOP AND RETURNED THE TRUCK TO ME IN ABOUT 10 MINUTES. THEY TOLD ME THAT THE SPARK PLUG WIRE HAD CAME LOOSE FROM THE COIL PACK. THIS HAPPENED TO ME 3 ADDITIONAL TIMES ON DIFFERENT CYLINDERS.
- Michael O., Burlison, TN, US
engine misses when idling in park or drive, changed plug wires, cleaned all plugs checked gap, went away for about 30 miles and started again, taking this vehicle in as soon as I get paid. nice truck but the bad miss is annoying.
- David V., Pineville, LA, US
Again jerking and vibrating and not going over 15 miles per hour. 2nd time in for same problem. Came out with a rattling dash and electrical board replacement
Update from May 13, 2015: Hope this is also resolved under electrical issue.
- ashe1130, Spring Hill, FL, US
Cylinder #2 misfire. Dealer states camshaft has failed and cause damage to the lifter on #2 cylinder and repairs will run $9748.00.
- Mike M., Kennesaw, ga, US