Headlights and turn signals failed. Flickering of various lights (Daytime running lamp, low beam, high beam, turn signals) followed by total failure. 3700 dollar repair at dealer to replace both headlamp assemblies. Barely over miles of warranty, but still in the 3 year warranty time period. Not having forward lighting is of course a major safety issue. Vehicle should be recalled. Many others are having the issue.

- Bruce Twp, Mi, MI, USA

On 11/21/24 noticed passenger headlight day light running light flickering. On 11/22/24 right turn indicator intermittent fast blink, dash message stated turn indicator failure. Once home, inspected passenger headlight assembly. Found DRL, turn signal, and low and high beam head lights were inoperative. On 11/25/24 went to GMC dealer/service. Staff seemed aware of issues and stated they are common, that they carry the $1,400 sealed assebly in stock. Vehicle is 4 months over warranty, but only has 29,000 miles. There is no visible damage to the assembly, but there is visible condensation inside the lens. GM has a published service bulletin, 01-08-42-001P, that specifically addresses this issue for my vehicle. The earliest date the issue could be diagnosed/service date is 12/10/24. A complete failure of this non-servicable headlight assembly is an absolute safety issue. Decreased daytime visability with the loss of one of two Daytime Running Lights, the lose of the front turn indicator to alert other drivers of my intentions, the lose of a set of low and high beam headlights. As mentioned, there assembies are a sealed LED light assembly. If any one of these lights fail, the only remedy is the replacement of the entire unit with a $1,400 part. GM has had multiple recalls of this same issue among their vehicle, but continues to produce the same failing pieces.

- Reno, NV, USA

Smog system check and Engan warning light keeps come on.

- Sacramento, CA, USA

The harness that hooks to bumper plug for trailer lighting is not completely water tight. Allows water in and creates buildup that weakens the connection as well as allows the plug wire connection to snap out and push out from the pin. Further inspection it was causing a short in the system. I attempted to clean and put some-electric grease on the plug to help clean it but then relaized 3 pins were broken and pushed back.

- Crosby , TX, USA

While driving the entire dash cluster (speed, rpm etc) turns off entirely, reloads as if truck is just starting with all lights coming off and on, needles cycling max/min. Unable to recreate on command, multiple others reported same issue with no cause/cure listed.

- Crosby , TX, USA