Jan '22 - Reported check engine light had begun to turn off and back on when gas tank was low. Feb '22 At 19k miles catalytic convertor reported failed for code (P0420), 3 way catalyst, upper and lower gaskets, and manifold all needed to be replaced - took 4 days Aug'23 called to request service for check engine light because it was coming off and on over periods of time. Scheduled for Sep'23 Sep '23 service reports new cat quoted for code P0420, I was not verbally informed by service advisor. 16 Nov '23 driving home and car starts to shake and is slow to accelerate, check engine light started to flash, car enters limp mode, could not drive safely on highway and waited hours for a tow. Codes P0420(cat convertor), P1326 (Knock sensor) 25 Nov '23 picked up car, had catalytic convertor, manifold gasket, knock sensor replaced. Drove 27 miles and car check engine light begins flashing again (P1326) on freeway while merging. Car hesitates, starts to slow, had to merge over to shoulder from far left lane as car had no acceleration. I felt unsafe to exit vehicle being 9 months pregnant. Waited 2 hours for tow back to service dept the same day I picked up vehicle. 8 Feb '24- picked up car from service department. They performed engine combustion chamber cleaning and reported excessive cylinder wall scoring. Service advisor feels confident this fixed the problem. I feel unsafe driving a car that has left me stranded multiple times on busy highways and freeways, especially with children. The manufacturer keeps replacing parts and cannot seem to diagnose issue, they keep repairing problems caused by a major issue that has not been diagnosed.

- Enumclaw, Wa 98022-2628, WA, USA