While in the house for ten minutes the Jeep caught on fire. The fire department stated that the fire was associated with the engine. The heat was sort of intense which melted the paint to the hood, making it difficult to open the hood by the mechanic.

- Helena, MT, USA

There is an oil leak at hte oil filter adaptor seals. Also, the cylinder head gasket leaks oil. They were replaced.

- Glendale Heights, IL, USA

Please note at the present time temperature gauge is not working after approx 6.gasket change water hose etc

- Montclair, NJ, USA

Oil pressure gauge dropped due to failure of the oil pressure sending unit.

- Bel Air, MD, USA

Support bolts that hold the engine have sheared off. Dealer and manufacturer have been notified.

- St Louis, MO, USA

Whenever driving vehicle at various speeds, without any warning, the engine would stall out. The engine check light would come on. Was running rough. Its an intermittent problem. Took vehicle to dealer at least 4-5 different times, but problem not solved.

- Northeast, MD, USA

The engine cylinder piston rings broke. Engine was making noises. Had engine taken apart & the piston was found to be broken. Manufacturer informed not a defect in engine.

- Edgewater, MD, USA

Belt pulley disintegrated after 2600 miles on new vehicle. Fragment of pulley was ejected at sufficient velocity to puncture hood leaving approx. 1/2 inch hole. At approx. 65 mph the engine RPM was only approx. 2500. It is possible that this failure could occur in a standing vehicle, causing a hazard to others.

- Brookfield, CT, USA