7.6

pretty bad
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
6,258 miles

About These NHTSA Complaints:

The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.

Get notified about new defects, investigations, recalls & lawsuits for the 1999 Jeep Cherokee:

Unsubscribe any time. We don't sell/share your email.

problem #48

Oct 092002

Cherokee 6-cyl

  • miles
1999 Jeep Grand Cherokee experiencing problems with bad rotors. The consumer experienced a severe shudder in the steering while attempting to brake at speeds of 45 mph. As a result the rotors were replaced on Oct 9, 2002. Shortly thereafter the rotors went bad again and were replaced on May 8, 2003, June 9, 2003, Mar 5, 2004 and June 2004. On July 8, 2004 the rotors were replaced with the new upgrade package at the consumers expense, however 9 months later the severe shudder returned.

- Presque Isle, ME, USA

problem #47

Jul 202004

Cherokee

  • 100,045 miles
Vehicle brake rotors found to be rusted severely. During a free brake check the technician determined that the rotors were severely rusted and disintegrated. This set of rotor were the replacement put on by the dealer for the recall. The vehicle has had 2 sets of rotors in five years. The consumer contacted the manufacturer for reimbursement.

- Beverly, MA, USA

problem #46

Jul 062004

Cherokee

  • Automatic transmission
  • 86,500 miles
The front rotors vibrated violently when attempting to stop from any speed, resulting in extended stopping distance.

- Las Vegas, NV, USA

problem #45

Oct 232003

Cherokee

  • 28,000 miles
Consumer complained about front brake rotors, the front brake rotors had been replaced on four separate occasions, but the problem still occurs.

- Santa Rosa, CA, USA

problem #44

Aug 012003

Cherokee

  • miles
The consumer has to replace the front rotors and pads. The consumer is concerned that vehicle is not on recall because it was not purchased in one of the states for recall #00V136000. However, vehicle is experiencing the same problems.

- Hudson, WI, USA

problem #43

Jun 202003

Cherokee 4WD 6-cyl

  • Manual transmission
  • 76,800 miles
Brake problems - rotors/calipers and wheel cylinders - all needed to be replaced.

- Towson, MD, USA

problem #42

Mar 142000

Cherokee 4WD 6-cyl

  • 9,052 miles
Front brake rotors and calipers had to be replaced for the third time. Tsb # 05 033 02 was issued by the manufacturer but they would not repair the brakes. The front brake rotors were replaced by the dealer under warranty. The consumer replaced at own expense. At 56K miles, the brakes needed to be replaced again. When the brakes were applied lightly, the steering wheel vibrated severely and was hard to control.

- Raleigh, NC, USA

problem #41

May 032003

Cherokee

  • miles
When the brakes were applied, the vehicle vibrated and caused extended stopping distance.

- Wichita, KS, USA

problem #40

Apr 202003

Cherokee 6-cyl

  • miles
The front rotors were worn, which caused the vehicle to experience extended stopping distance.

- Woonsocket, RI, USA

problem #39

Apr 022003

(reported on)

Cherokee

  • miles
The vehicle experienced extended stopping distance, the dealer resurfaced the rotors, however 1 year later the problem recurred.

- Rockledge, FL, USA

problem #38

Jan 282003

Cherokee

  • miles
While driving front brake rotors wore out, causing extended stopping distance.

- Priest River, ID, USA

problem #37

Nov 212002

(reported on)

Cherokee

  • miles
The consumer states that the dealer is aware of the brake/rotor problem but doesn't seem to make a permanent fix. The consumer states the every 6-9 months(average)the brakes/rotors must be repaired-3 times.

- Unkown, IA, USA

problem #36

Sep 232002

(reported on)

Cherokee

  • miles
When brakes are applied at high speed front wheels vibrate. Brake rotors were recut down at 28,000. Failure reoccurred after some mileage accumulation.ak

- Fort Wayne, IN, USA

problem #35

Jul 202002

Cherokee

  • miles
While driving at 65mph, the brakes began to grind, and the wheel bearing on both sides were making noise. The consumer states that both front hub bearings and axle seals were replaced at the dealer. The rotors were completely destroyed with the factory pads intact. The pad were still good. The rotors however were so thin that they crumbled(very dangerous). Now the rear hubs are loud an need replacing. The consumer has replaced the rear wheel bearing, and the bearings on the rear axle in the hub are seperated/extremely dangerous-part of the bearing are spinning in the inside of the hub.

- Gladewater, TX, USA

problem #34

Apr 012002

(reported on)

Cherokee 4WD

  • miles
Consumer had the rotors replaced twice and is currently in need of new rotors again.

- Chase City , VA, USA

problem #33

Jan 072002

(reported on)

Cherokee

  • miles
Rotors went bad. Also, PCM had to be replaced. Please provide any further information, and vehicle identification number.

- Edna, TX, USA

problem #32

Jul 112001

Cherokee 4WD

  • miles
Brakes/rotors originally failed at 13,242 miles and dealer replaced as a "good will " gesture. Brakes/rotors again failed or warped out of round at 29,569 miles and dealer was requiring me to pay in full. After much arguing dealer suggested to reduce owner costs to half, but still insisted that problem was misuse of vehicle.

- Baltimore, MD, USA

problem #31

Nov 132001

(reported on)

Cherokee

  • miles
When brakes are applied vehicle vibrates out of control. Dealer has replaced rotors and brakes several times because rotors become out of round.

- Baltimore, MD, USA

problem #30

Nov 072001

(reported on)

Cherokee

  • miles
When brakes are applied vehicle vibrates uncontrollably. Dealer has replaced rotors, and brakes several times because the rotors were out of round.

- Baltimore, MD, USA

problem #29

Aug 062001

(reported on)

Cherokee 4WD

  • miles
Since 37,000 miles, rotors were warped, with braking pulsation-machined. #2 warped rotors within 3 mo. New rotors. Warped rotors within 3 mo. Rotors machined-new brake pads. Another three months rotors warped. And grinding noice when brake pedal fully engaged. Believe a design flaw to be present causing the rotors to warp continually. This manifests into pulsation when braking more often than not.

- Durham, NC, USA

Read the next 20 complaints »