While driving at any speed consumer heard a loud clicking sound coming from the wheels. Vehicle was taken to an independent mechanic, who informed the consumer that the rotors needed to be replaced.

- Blue Bell, PA, USA

Consumer has had recall, 00V136, work done, however rotors continue to warp, ABS module needed repaired, brakes are noisy, brakes pulsate, and ABS light illuminates, because of brake problems, tires had to be replaced and have to be rotated often, dealer stated there may be a hazardous condition in the future with the ABS.

- Scarsdale, NY, USA

Consumer accelerated after a stop and vehicle began to go backwards. Consumer applied brakes and accelerated again, vehicle repeated itself. Consumer put vehicle in park and back to drive, it was normal. Manufacturer is aware of problem, but nothng could be done until a recall is issued. Consumer also stated that vehicle has had 2 sets of brakes at 22,000 miles.

- Cincinnati, OH, USA

Consumer has had recall, 00V136, work done, however rotors continue to warp, ABS module needed repaired, brakes are noisy, brakes pulsate, and ABS light illuminates, because of brake problems, tires had to be replaced and rotated often, dealer stated there may be a hazardous condition in the future with the ABS.

- Scarsdale, NY, USA

The ABS module and rotors failed and were replaced, the front brakes make noise and the rear brakes were worn out.

- Scarsdale , NY, USA

The ABS module and rotors failed and were replaced, the front brakes make noise and the rear brakes were worn out.

- Scarsdale , NY, USA

Tapping on the brakes they make a grinding sound. The rear brakes were replaced but the problem has come back. After the dealer checked it out to see why the noise won't go away the dealer claimed it was normal.

- Rockford, IL, USA

Brakes failed prior to the recall.

- Palm Coast, FL, USA

Brakes pulsate causing pulling and steering wheel vibration, replaced pads and rotors, replace all four rotors the second time, scraping noise from rear axle, bad end bearing and cracked skin in rear axle, replaced rear axle gear set.

- Smithfield, RI, USA

Front and rear brakes corroded.

- Colton, NY, USA

Continued brake problems, several repairs and not able to be completely rectified. Mjs

- Big Stone, VA, USA

Brakes continually require repairs and replacements due to failure causing pulsating. Mjs

- Ewa Beach, HI, USA

When the brakes are applied they pulsate. Dealer has replaced brakes at 20K miles. The vehicle currently has 38000 miles and problem reoccurred. Manufacturer has been notified.

- Colts Neck, NJ, USA

Rear brakes and rotors failed.

- Ann Arbor, MI, USA

When you step on the brakes car starts to vibrate (only happens on low speed between 20-40 mph)

- San Jose, CA, USA

Brakes intermittently fail when going over bumpy surfaces. (qcaw)

- Wilmington, DE, USA