Replace the bulb three times in three months. Paid to fix parts twice. Went to Jeep dealer on 2286 Flatbush Ave and was charged to fix light when I bought the vehicle to them for a recall. They charge me $328.58 and do not even have the part. I just paid for the part on July 1 and had it install by a mechanic and its not working again. I was never told they were going to charge me $269 to look at that issue regardless if they fixed it or not.The young lady was new but did not say that I had to pay the $269 to look at it until after she called me on the phone to tell me oh it not under warranty. They are some scam artist. i will never in life buy or bring my vehicle to Chrysler again or have any family or friends purchase from them or any Chrysler dealer. So now I paid for the service and am waiting for a week until the part comes in.

Same damn issue with the rear tail light. Was pulled over by officer had to show him that I just paid all this money to get fixed and still not working. I also showed him the bill from when I originally purchased the part the first time on July 1 from 2286 Flatbush Ave dealer. Now waiting for a week for part to come in then to go back for them to replace. The sad part is this vehicle is hardly on the road. I pay twice for the same issue. You can't tell me this sh*t should not be recalled, it only have a lit bit of miles. If I get pulled over again and get a ticket I am taking them to court to pay for it.

What is there to say? It is a crappy piece of S!%% that should be recalled, but why hold my breath? It is a Fairly simple fix. If you keep replacing the Bulbs or they work intermittently, here is the problem. The circuit boards for the bulbs melt over time or water gets in there and they rust. Good news. You do not have to buy a complete Brake Light assembly, just the circuit board. Here is the Link for it: http://www.ebay.com/itm/271795770180?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT

If you cannot click on it, just copy and paste. The most difficult part of it is removing the old one. The only thing Holding the Tail Light is is 2 Phillip Screws and 3 Light socket Plugs. The light, when screws are removed will seem hard to get out. No worries. Just Pull hard and evenly/straight with a lot of pressure, no yanking or jerking.