10.0
really awful- Crashes / Fires:
- 1 / 10
- Injuries / Deaths:
- 2 / 0
- Average Mileage:
- 35,802 miles
About These NHTSA Complaints:
The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.
Timing chain and misfire bank 1 and bank 2 crank shaft and crank sensor issues.
- Palmerton , PA, USA
I am reporting a persistent and safety-relevant defect in my 2012 Jeep Wrangler with the 3.6L Pentastar engine. The vehicle is experiencing misfires on multiple cylinders, especially cylinders 1 and 5, triggering codes P0300, P0301, and P0305. These misfires result in loss of power, hesitation, and rough idle, creating serious safety concerns during acceleration or highway driving. Despite replacing spark plugs, ignition coils, the crankshaft position sensor, purge valve, and both oxygen sensors, the problem continues. The vehicle has just 83,000 miles and is currently at a certified third-party repair facility. Multiple mechanics believe the issue stems from known defects in the left (Bank 1) cylinder head or valve train components-?"an issue Chrysler previously acknowledged via TSBs and a 10yr/150k mile extended warranty on select VINs. I contacted Jeep Cares and requested goodwill support, but they refused to even discuss the issue because my Jeep is not at a dealership. This leaves owners like me with limited, expensive options despite being affected by a well-documented defect. Jeep forums and independent shops have seen widespread misfire problems on early 3.6L Pentastar engines, especially 2012-2013 models. I urge NHTSA to investigate this pattern of failure. The misfires impact driveability and safety, and the manufacturer has not offered sufficient resolution or consistent support to affected customers. I-??m happy to provide additional information, documentation, or diagnostics.
- Edwardsville, IL, USA
Engine spontaneously caught fire. It had been parked for hours before it happened. Everything under the hood was totaled
- Atascadero, CA, USA
The contact owns a 2012 Jeep Wrangler. The contact stated that while operating the vehicle the ABS, Traction Control and check engine warning lights had remained illuminated. The contact indicated that while pressing the brake pedal to stop, the brake pedal extended to the floor causing the braking distance to become extended. The vehicle was taken to the local dealer who diagnosed that the ABS module was faulty and needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure but no assistance was offered. The failure mileage was 55,000.
- Baytown, TX, USA
In my 2012 Jeep I had to replace the engine and catalytic converters. The engine number 3 cylinder failed due to excessive ware causing lower compression. After the engine (long block) was replaced, one of the cylinders was miss firing. This miss firing was traced to micro cracks in the plastic/composite intake manifold (original and not part of the engine replacement). Because these micro cracks changed the fuel air ratio on specific cylinders by leaning out the cylinders near the cracks this lean mixture would cause the affected cylinders to run hot that would lead to both the excessive ware on the one cylinder and would comprise the catalytic converters. Because this change in fuel air mixture was caused by the intake manifold and Jeep does not have any inspection requirements or methods for this item and even after the Jeep Dealer did a full diagnosis using their factory specified equipment the issue with the manifold was not found. My local AMMCO shop found the cracking in the manifold that was the route cause of the problem.
- Great Mills, MD, USA
Jeep Wrangler 3.6 liter 90k miles lifter making loud noise. Seems you had a recall about this on the 2012 and guess I missed out
- Irvine, KY, USA
6 days after an oil change, the temp gauge while driving went from cool to hot in under a mile and the engine temp light came on. There was coolant all over the underside of the car it was near catastrophic. I had to have it towed to the dealership for repairs. The faulty part was the oil filter adapter it was cracked by over tightening of the oil filter.
- St. Peters, MO, USA
Engine Stalls Randomly while Driving. Will crank over several times and over approx 10-15 min. of cranking(Say every 3-5min) vehicle will and will restart. No check engine lights and no warning. The loss of power can be dangerous since brake and steering assist require engine to be running. Vehicle will be fine for several days local commute and problem will recur without warning, usually on longer commute. Vehicle is unsafe and unpredictable.
- Sterling, VA, USA
Cam sensor failed. Check engine light and traction control light appeared. Replaced and same problems occurred. May be wiring or cam/rocker issues.
- Clinton, UT, USA
The contact owns a 2012 Jeep Wrangler. The contact stated while starting the vehicle, there was an abnormal burning odor around the vehicle. The contact stated while driving 45 MPH and other various speeds the burning odor was still present. The check engine warning light illuminated with the temperature gauge rising from normal to hot. An audible alarm was heard during the failure. The vehicle was driven to the residence and then towed to a dealer. The vehicle was diagnosed and determined that the radiator needed to be replaced. The contact had the vehicle towed to an independent mechanic who determined that coolant was leaking into the cylinder head. The vehicle had not been repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 60,000.
- Houston, TX, USA
While driving the car randomly stalls. I lose power steering and braking. The car will not restart. This issue has been recorded by the dealer. The vehicle was last inspected on July 5th. I have been issued a Jeep Care case manager, case # 82963828. There are no warnings, while driving makes a left-hand turn the car just stalls!
- Verona, WI, USA
While driving making a turn, shifting from 1st to 2nd gear, and vehicle stalls losing all power. I had a crank no-start scenario! The vehicle has been to the dealer multiple times and the issue can not be duplicated. The vehicle has been inspected multiple times and there are no known issues. No-fault codes are thrown. I was able to cost to a safe location, and wait. after 3-5 min the vehicle restarted.
- Verona, WI, USA
While driving making a turn, shifting from 1st to 2nd gear, and vehicle stalls losing all power. I had a crank no-start scenario! The vehicle has been to the deal multiple times and the issue can not be duplicated. The vehicle has been inspected multiple times and there are no known issues. No-fault codes are thrown. I was able to cost to a safe location, and wait. after 3-5 min the vehicle restarted.
- Verona, WI, USA
While driving making a turn, shifting from 1st to 2nd gear, and vehicle stalls losing all power. The vehicle has been to the deal multiple times and the issue can not be duplicated. The vehicle has been inspected multiple times and there are no known issues. No-fault codes are thrown. I stalled in the middle of a busy intersection, with my children in the car. I had to push the vehicle to safety!
- Verona, WI, USA
Starting out at a stop sign. engaging the clutch to start moving, while shifting into 2nd gear while turning the vehicle stalls. Losing all power steer and brakes. I try to re-start the car i get a crank no-start scenario. Wait 3-5 min, retry starting the vehicle starts.
- Verona, WI, USA
Starting out at a stop light, engaging the clutch to start moving, I depressed the clutch to shift into second gear while making a turn, the vehicle stalls, losing all power.
- Verona, WI, USA
I was driving on the highway and the engine caught fire. I-??ve been looking for an engine to rebuild and all of them had previously been on fire. I believe the engine is defective for the jeeps that year, make and model.
- Grovespring, MO, USA
While driving the car stalled. Loss of power steering and braking. I was able to coast to a safe location. I tried to restart, but Crank- No Start.
- Verona, WI, USA
Random Stalling while driving, making a left-hand turn. While entering an intersection, the vehicle stalled losing all power. Was able to coast to a safe spot. Waited 15 min, the vehicle started. No check engine light.
- Verona, WI, USA
- Independence, MO, USA