10.0

really awful
Crashes / Fires:
0 / 1
Injuries / Deaths:
0 / 0
Average Mileage:
38,967 miles

About These NHTSA Complaints:

The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.

Get notified about new defects, investigations, recalls & lawsuits for the 2007 Mercedes-Benz ML350:

Unsubscribe any time. We don't sell/share your email.

problem #3

Jun 272016

ML350

  • miles
The contact owns a 2007 Mercedes-Benz ML350. The contact stated that the control module prematurely corroded and the dealer (Mercedes-Benz of sacramento, 1810 howe ave, sacramento, ca 95825,1810 howe ave, sacramento, ca 95825) failed to ensure that the module case was covering the area when the vehicle was sold. The dealer stated that the vehicle was excluded from a manufacturer recall and refused to provide a solution. The failure was reported to the manufacturer and the contact was waiting to determine if they could assist. The failure mileage was not available.

- Sacramento, CA, USA

problem #2

Apr 052013

ML350

  • 80,000 miles
The contact owns a 2007 Mercedes Benz ML350. The contact stated that there was a burning smell inside vehicle. The alternator and battery warning lights were also illuminated. The vehicle was taken to a dealer, who inspected the vehicle and found water in the spare tire compartment. The water entered the lift gate control module and caused the module to shorten and burn. The vehicle was not repaired. The manufacturer was not made aware of the failure. The approximate failure and current mileage was 80,000.

- Middlebury, CT, USA

problem #1

Sep 022011

ML350

  • 36,900 miles
Defect/ mechanical failure of front passenger jack mount. I had jacked up the front passenger side of my 2007 ML350. Both back wheels were blocked with automotive wheel blocks. The parking brake was engaged, and the vehicle was in park with the motor off. The vehicle was parked on my cement driveway. I carefully place the jack to ensure it engaged into the jack mount and that the base of the jack was secure and stable on the cement. I loosened the lug nuts prior to jacking the car. After removing the wheel, I rolled the wheel out of the way and went to get a jack stand from the opposite side of the vehicle. Moments later, the vehicle fell. The jack mount had failed and the extended jack damaged the front fender, jack mount, and underside of the vehicle. I believe I took all reasonable precautions in jacking the car and I am very surprised and concerned that this occurred. I could have been seriously injured. These jacks are typically for use under much less ideal conditions. I have contacted Mercedes Benz head office in writing since the service manager at a local dealer suggested it was not mb fault. I also wrote them via their online email submission form on the corporate website - they have not responded.

- San Diego, CA, USA