2011 Nissan Murano, While pulling into a parking area the left rear (drivers side) wheel collapsed. Fortunately this happened at a very low speed, (under 10 MPH). Upon inspection it was discovered that the lower control strut had rotted out and separated from the frame causing the wheel to collapse. If this had occurred on a main road at speed it could have caused a very serious accident due to loss of control. In this case it did not happen, as stated it was at low speed and in a parking lot. The deterioration of this strut was never called out by dealer inspite of numerous Multi-point safety inspections during normal periodic vehicle servicing. There was no warning of impending failure, it just occurred! Neither Nissan or the dealer claim any responsibility for the failure of this part(s) Both sides were replaced as both sides had rotted out.

- Peabody, MA, USA

The contact's husband owns a 2011 Nissan Murano. The contact stated that while driving up an incline at approximately 35 degrees and making a sharp left turn, the vehicle failed to accelerate. The contact then stated that he attempted to apply more pressure but the vehicle failed to accelerate and moved at a slow pace. The contact then stated that after he was in the driveway, he placed the shifter in park and then back in drive position but the vehicle hesitated then failed to accelerate. No warning light illuminated. The dealer was notified of the failure and an appointment was scheduled. The vehicle was not diagnosed. The dealer nor the manufacturer was not notified of the failure. The approximate failure mileage was 131,000.

- High Point, NC, USA

The brake pedal has suddenly become very unpredictable. Sometimes when depressing it they start engaging where they normally would & sometimes you have to depress it all the way to the floor to get it to stop. My daughter informed me of the problem so I drove it to pick up pizza. When parking at the pizza place it happened to me..... I jumped a sidewalk curb almost hit people walking on the other side because the brakes didn't engauge in time. My problem has not been confirmed by a dealer service center but the exact same problem is listed with the 2009 Murano & has been recalled because of a reaction with a metal plating turning the brake fluid to a gelatin solution after 10 years. This 2009 Murano recall was in 2019. My Murano is 10 years old now. & has under 80,000 miles & had new brake pads put on 15,000 miles ago even though they didn't show much wear. I live in a rural area & the closest Nissan dealer over 50 miles away so I can't just drop by a Nissan dealership. No warning lights have come on with this vehicle as of yet. This Murano is my 16 year old daughters & she is not very tall so she is not able to depress the brakes far enough to stop when this happens. I have had to park the Murano until we get this problem resolved. Please respond with how I can resolve this braking problem. Thanks

- Calhoun City, MS, USA

For the second time my anti-lock brakes have gone out and the paddle for the break goes all the way to the floor. It barely stops and I'm afraid it's going to happen where it doesn't allow me time to stop. This should be a recall. From other complaints found on the internet many people are having the same problem.

- Ocala, FL, USA

Car started running rough, sluggish on going from still at stop to not wanting to go when acceleration should happen. Then ABS light came on, followed by all the trouble lights on other side of panel. Car would only go about 5 mph. I turned car around and headed home, but it wasn't a smooth ride. I got up to about 45, but it still seemed sluggish and braking was stiff. This happened 2 years ago. Dealer said no recall for 2011, but previous and following years did have recall for this. About 2 weeks after we went to dealer and started a conversation with Nissan corporate, the car stopped having the problem and was fine fir 2vyears until now.

- Lithia Springs , GA, USA

Brake peddle went to the bottom. There was no braking at all. Brakes did not work on 2/12/21. Pumped it a number of times, but still no brakes.

- Oak Forest, IL, USA

My car is working perfectly fine and with oil change at Nissan dealer (30 days back), I found no issues. Today, while driving at 30-35 mph, the brakes pedal went all the way to the floor and car did not stop easily on the turn. I was almost going to hit another car but survived. There was no pressure in the break pedal at all. The same thing happened year or so ago but did not report the issue thinking this might be due to break pad etc. But it happened again and now I don't even want to take out car on the road. I called Nissan North America after reading same issues on internet and their response was plain - "there is no recall on this vehicle" and you have to check with dealer and fix at your own cost. My question is - if there are so many complaints on the same issue and have recall with same model for 2009, how come 2011 model is not on the recall" are there any #of complaints/accidents need to be reported before Nissan takes any action"

- Kirkland, WA, USA

The ABS actuator has been under recall by Nissan for certain models. After contacting Nissan customer service they have determined due to the mileage of the vehicle this safety defect is not covered under the recall.

- Gonzales, LA, USA

When braking hard the brake pedal softens and doesn't brake well it's dangerous and I was informed it was a manufacturing error. It happens all the time city highway pulling out of my drive way the vehicle can be moving or stationary this problem still occurs I was told it's the actuator and ECU antiskid.part number 47660-1swoc supersession 01225-1aa6C;47660-1aa6B;47660-1aa6C;476601swoc

- Haines City, FL, USA

Over the last year, for some reason the brakes pedal will go almost all the way to the floor when attempting to stop the vehicle. This happens from time to time and will cease after a few hours or a day or so and the brakes will return to operating normally. We have had the car (SUV) checked and inspected multiple times, and each time the mechanics cannot find anything wrong. I have read of other owners of the same make and year vehicle who have the same problem and have not been able to resolve it. In our case, we have not rear ended someone (yet), but it appears that others have come very close. We just took the car to the dealership two days ago and the issue reappeared again. While they had it, the brakes were working fine, after we got it home, it started happening again where the brake pedal went all the way to the floor, making it difficult to stop the vehicle. A few hours later, the issue disappeared and the brakes were working fine. Help please, before a family gets seriously injured or a family gets killed.

- Henrico, VA, USA

Several months ago, we drove over a big dip in the road. As we came upon a stop sign just past the dip, the brakes went all the way to the floor before coming to a stop. The brakes continued to push to the floor for several days afterwards before finally going back to normal. A couple of months later, the same problem happened after going over a bump. This has happened several times over the past several months. However, the last time it happened, the brakes never got better. I took my Murano to a brake mechanic. They did diagnostic testing which showed the left front and right rear are not compressing. They believe the problem is a faulty hydraulic control unit. The 2009 Murano was recalled for this same issue. The 2011's should be also.

- Mcminnville, TN, USA

On Feb. 6th 2020 I was driving my 2011 Nissan Murano (62,000 miles) at 55 mph when I came upon some traffic. When I applied the breaks they went to the floor & I had to pull onto the grass & pump the brakes till the car finally came to a stop. I was 250 miles from home so I stopped at a Firestone store to check out my brakes. 5 hours later, the car was ready--they bled the air from the brake lines & when I got back on the road everything was okay. On May 29th, 2020, I was driving & coming on to a road construction crew. I went over 2 sets of speed bumps & when I applied the breaks, they went to the floor. I pumped the brakes & applied the emergency brake to stop the car because there was traffic stopped in front of me. I took the car to my local mechanic & they installed a new master cylinder & bled the brake lines 3 different times. They had the car for 1 week & the car would not stop at slow speeds till the brake pedal was almost to the floor. The car is not safe to drive. On the internet, I can see the numerous complaints about braking on the 2011 Murano. There was a recall on the 2009 models & I think the 2015 models. Nissan needs to step up & correct the problem on the 2011 models. This is a very dangerous situation that requires a recall of the 2011 models. Right now the vehicle is sitting in the garage because the dealership is 65 miles away & the car is not safe to drive.

- Point Blank, TX, USA

When I press the brakes the brake pedal goes all the way down to the floor. It feels horrible unsafe because you must push the pedal as far down as it can go to get it to begin to brake. I was pulling into a walmart parking lot when the problem first happened.

- San Antonio, TX, USA

The contact owns a 2011 Nissan Murano. The contact stated that while pressing the brake pedal the vehicle would not immediately stop. The brake pedal had extended to the floor and the stopping distance was extend. The vehicle was taken to an independent mechanic who replaced both the front and rear brakes, ABS module and master cylinder but the failures continued to occur. The manufacturer and local dealer (unknown) was notified of the failure but no assistance was offered. The failure mileage was 120,800.

- Clayton, NC, USA

I was exiting the highway when a car abruptly pulled in front of me and I had step on the brakes with great force to stop in time without crashing. Immediately afterwards when I had to use the brakes again at a red light, I had to push down the brake pedal almost all the way down to the floor to stop the car. The brakes felt spongey and provided almost no resistance to my foot as I pressed down. The issue persisted for a few days before I took it to a local mechanic. They tried several of the standard fixes when this type of brake issue arises, including going as far as to replace the master cylinder, which did not fix the issue. The brake issue only was resolved once they put the car in the air, accelerated, and pumped the brakes multiple times which eventually, somehow brought the brakes back to normal capacity. The mechanic says he has seen this issue in many Nissan Muranos and he speculates that the these models have a faulty ABS sensor module which causes the brakes to lock up if used too hard. I've had this issue 3 times in the last 2 years, this was the first time the brakes had stayed unusable for several days, posing a major safety issue. I've read online on many websites and have read this same issue being had by other 2011 Nissan Murano owners. The ABS sensor module can cost up to $2,000 just for the part itself. With so many complaints, Nissan should issue a recall to repair this major safety issue before someone's brakes go out on the highway and cause a loss of life.

- Maple Grove, MN, USA

Without warning brke pedal began to fade. No leaks, no warning lights noted. Dealer quotes parts at $1995 and labor of $400 plus to repair in conjunction with pads and turned rotors total $3,200. Note - this corresponds to issues with the 2009 and 2015-2017 recalled Muranos for the samed ussues est milaege 90K

- Elkton, FL, USA

The contact owns a 2011 Nissan Murano. While driving approximately 35 mph and attempting to slow down, the brake pedal traveled to the floorboard when it was depressed. The contact pumped the brake pedal until the vehicle stopped. There were no warning indicators illuminated. The contact stated that the failure occurred for at least two months. The vehicle was taken to an independent mechanic and the master cylinder was replaced, but the failure continued. The vehicle was not taken to the dealer for diagnostic testing. The manufacturer was not notified of the failure. The vehicle was not repaired. The approximate failure mileage was 51,499.

- Jacksonville, NC, USA

When coming to a stop at light, when I pushed on the break to stop, the brake pedal went all the way to the floor and car will not stop. After pumping the break several times the car will eventually stop. This has happened numerous times in the last 3 weeks. I have taken my car to the dealer and other car shops and they see no visible evidence of any problems at all. I'm at a loss and my wife and myself are terrified to drive the car anymore.

- Richmond, TX, USA

Without warning, brakes begin to feel spongy, have to press brake pedal almost to floor before response. Several close calls now as a result of intermittent changed braking performance. As a result, had brakes checked, fluid drained, master cylinder replaced, brake lines drained, no change in performance. Not comfortable driving car, feels unsafe.

- Durham, NC, USA

Intermittent problem while driving when depressing the brake pedal it will go all the way to the floor and produce very little braking ability. On several occasions evasive action had to be taken to avoid collision. Has occurred while driving in stop and go traffic as well as on a highway. The problem appears to correct its self after vehicle is parked for a period of time. No warning lights or service indicator lights/ codes present. This problem has occurred sporadically absent of any fore warning and presents the possibility of accidental collision. This same condition has been reported in the same model over several manufacture years and although indications are the the same ABS control module has been found to be at issue only the 2009 year was issued a service recall.

- Theodore, AL, USA