Recently I have had warning lights turn on my dashboard in my truck. Also any time I press the brake petal anti lock brakes lock in. The warning lights are ABS light, and TCS light. As a result of these lights they have also thrown other codes. The check engine light came on shortly after, the service electronic throttle control warning, as well as the BRAKE warning light. I was instructed to check all fuses and replace all ABS sensors to correct the issues. I have replaced all sensors with brand new OEM sensors and it did not fix the problem. I took it to my local mechanic and they said the truck needs a new ABS control module, as well as a new Hydraulic Control Unit/HCU. They preceded calling the Ram dealership to order the parts only to find out that the ABS control module is on back order and I might be able to get one by February. They also said that they stopped making the HCU and don-??t have any available because it was a faulty part and they haven-??t come up with a new design yet. They said that they aren-??t accepting any orders for HCUs until at least February (IF) they have the new design completed by then. But it will most likely be on back order. Upon researching the issues with my truck, I am not alone and there are hundreds of people with the same issue. I think Ram should issue a recall and fix this issue as it is a major safety concern. Many people have lost their brakes while driving from this issue. My mechanic informed me that I could still drive my truck but he wouldn-??t because I could very well lose my brakes. I am also concerned that it may cause other issues if it is driven without fixing the issues. So now I am out of my work vehicle until I can get this fixed, but it-??s virtually impossible to get it fixed because they are not making the part anymore. Thank you for taking the time to read my concerns. I hope Ram is held accountable for these faulty and dangerous malfunctions.

- Romney , WV, USA

Since purchasing in 2014 I have had my truck in and out of RAM Dealerships for steering issues and braking issues. Repeatedly told that it-??s a RAM. A steering linkage recall was received and I took it in to have it done. Problem has been there continuously. The water pump issues continue Brakes are still an issue BUT I have been told at the Dealerships that they are hydraulic and they work differently.

- Lawton , OK, USA

RAM has Turbocharger/actuator high failure rate. I have had 2 turbo failures in under 80,000 miles. When I lost the turbo I loose the exhaust brakes. This is very dangerous when towing and coming down a mountain road. This could lead to vehicle damage and loss of life. IN FACT: RAM on the 2015 model year only, issued a warranty extension for Turbo failures. This is serious safety concern due to NO exhaust brakes or no acceleration when needed to avoid a collision.

- Yakima, WA, USA

Truck was in minor accident, hit in rear. Usaa insurance. Usaa admitted liability for claim and referred to mike's autobody in concord, ca. When the vehicle was picked up from the body shop I told mike's autobody that the brakes seemed to go to the floor and they were fine when I brought the truck in for the body work. Mike's autobody refused to look at the brake issue, stating that they did not do anything to the brake system. The next day my son was born. Going to the hospital with my wife in labor and returning with my infant son I noticed the brakes almost not functioning. We almost had an accident. The brakes continued to degrade. A local brake shop inspection report stated that the brake lines were smashed under the truck bed not accessible without removal of the truck bed. I again asked mike's to repair the issue. I demanded they repair or I would have to seek legal action if they did not take care of the safety issue the manage of mike's autobody refused and said "see you in court." Dodge dealer confirmed that the brakes lines were crushed when mike's autobody. Dealer took photos of entire process removing truck bed and brake lines were crushed when mike's autobody installed the truck bed.. my request is that the NHTSA issue a citation to mike's autobody and usaa insurance for failing to address a complaint about a potentially life-threatening safety issue to motivate them to respond appropriately to serious highway safety issues in the future. Usaa representatives also did not take the issue seriously and attempted to avoid fault by stating that the brake issue may have occurred during the accident 2 years ago, in their reply to the complaint submitted to the insurance commissioner. Even if that were the case, they are liable. Evidence shows that the brakes were damaged by mike's autobody

- Pleasant Hill, CA, USA

The E-brake on this vehicle does not hold even on a slight incline. When the truck is light with interior weight the E brake will not hold, so when it is heavy with equipment it is even worse. This is a hazard and can cause a serious accident. We have had this looked at several times by our Ram promaster diesel mechanic and was told it was a "poor design" and there is nothing we can do. This issue has been happening since we purchased this truck new.

- Jackson, NJ, USA

Date 2/18/2018 and at mileage 68,000 power steering pump and the high pressure hose to booster failed. The failure resulted in lack of steering and brakes at highway speed driving to work.

- North Little Rock, AR, USA

Loss of power steering and very little braking power. Extremely dangerous. Calling dealership when they open and getting it towed in for warranty service asap. Too many problems and recalls on this truck!!!!

- Martinez, CA, USA

Left front caliper is not releasing, one or both pistons seem to be hanging up. Inconsistent problem while driving and when this happens, vehicle pulls hard left when braking. Been to dealer twice and all they did was lube the slide pins. Now vehicle is past 3/36 warranty

- Colorado Springs, CO, USA

The contact owns a 2014 Ram 2500. While driving on several occasions, the anti-lock brake and check engine warning indicators illuminated. While the brake pedal was depressed, the brakes failed to operate as intended. The dealer diagnosed that the alternator and battery needed to be replaced, and the anti-lock braking module needed to be re-calibrated. The vehicle was repaired; however, the failure recurred. The manufacturer was notified of the failure. The approximate failure mileage was 8,000.

- Stoneham, MA, USA

The contact owns a 2014 Ram 2500. While driving 70 mph, the steering and braking failed without warning. The contact turned on the hazard lights and forcefully steered to the side of the curb on a hill to stop the vehicle. The vehicle was towed to a dealer where it was diagnosed that the water pump bearing and serpentine belt were not installed, and the coolant failed. The vehicle was repaired. The manufacturer was made aware of the failures. The failure mileage was 49,294.

- Yuma, AZ, USA

The integrated brake control system does not apply enough breaking power to the trailer. I have tried setting the gain from 0 to 10. I have used the manual trailer break control and had the same results. I can hear the trailer breaks engage at slow speed but this does not apply enough braking power. The trailer breaks have been checked and are good. The trailer has also been connected to another vehicle and the brakes worked as designed.

- Jacksonville, NC, USA

Factory installed trailer brake controller on the highest gain setting only slows truck and trailer minimally. After market brake controllers do a much better job.

- Acampo, CA, USA

My 8,000lb trailer will not slow down even after adjusting and checking all 4 electric brakes. F-150 hooked up to same trailer in same condition will stop the trailer very fast. Many people are having this issue. See below: Continental makes the itbm for Chrysler to Chrysler's requirements. Itbm was redesigned for MY13 and was used in 2013 and 2014 production which had a newly designed electrical architecture introduced for the 2013 model year. The new architecture changed the traditional brake switch signal and made it impossible for after market trailer brake solutions until the after market developed an interface cable. Chrysler again changed the brake signal back to traditional signaling but for an unknown reason (and also undocumented), designed a 70% maximum output from the itbm at speeds below 30mph. What makes this move more mysterious is the manual slide on the itbm, typically used to set the gain of the itbm's output, will not put out maximum braking, but is also limited to the 70% rule making setting your gain impossible as instructed by the owners' manual. We are all waiting for something to happen from Chrysler, all that is needed is a software update. I was told by Chrysler, if a change was made, it would be introduced in the next Ram hd refresh now scheduled for 2019. That was before more noise about this issue. Depending on what voltage your trailer's brakes require for forceful stopping determines if you will see the 70% rule issue. For example, my Montana needs 10.5 volts for a forceful stop, I'm out of luck. My utility trailer only need 6 volts, no problem, just difficult setting the gain.

- Rock Springs, WY, USA

The contact owns a 2014 Ram 2500. The contact stated that while making a turn, an abnormal sound was heard from the passenger side tire and the front wheels seized. The anti-lock brake system and the traction control warning lights illuminated. The 'service anti-lock brakes' warning message displayed. The contact mentioned that the tire on the front passenger side was completely ripped off due to the failure. The contact coasted to the road. The vehicle was towed to the contact's residence. The front passenger tire was replaced by the contact and was taken to the dealer where the cause of the failure was not determined. The vehicle was not repaired. The manufacturer was made aware of the failure. The approximate failure mileage was 23,000.

- Norwalk, CT, USA

The contact owns a 2014 Ram 2500. While driving approximately 50 mph, the front driver side wheel began to shake and there was a burning odor from the driver side. The front driver side hood area began to smoke and the control began to become unstable. The ABS warning light illuminated and the brakes became inoperable. The contact took the vehicle to the dealer who stated that the vehicle was unsafe to drive, but no official diagnostic was given. The failure mileage was 34,000.

- Utopia, TX, USA

2500 hd outdoor edition, 2014. I purchased this truck with 7 miles. At 371 miles the brake sensors were staying engaged and I had a thick layer of brake dust coating the rims and burning brakes. The pass. Side dash was falling apart and the carpet was shredding on that side also. They adjusted the sensors to read the same pressures inside and outside of the brake drum. Reset and reprogrammed many computer sensors. Then my key fob quit working, rear sliding window and tire monitor systems all stopped while I was traveling the mountain pass at 75 mph. From Sept, 14, 14, when I unlock the truck with the key every alarm goes off and will not shut off until I start the truck. I could not get the dealership to order my parts or fix my truck so, in January I got an ABS recall at this point I called Chrysler Corp and filed a consumer complaint with their repair team. They contacted the dealership with my concerns. Since, they have changed/reset almost every sensor in this vehicle. From the navigation system, the radio system, they ABS etc. Key fob bad still, (3fixes). Computer still malfunctioning badly (6th, fix). The locking unit went out of the sidebox toolboxes, the driver door control panel went out. Odometer reads out at 12 miles over for every 28 traveled. I have documentation and records for 7100 miles, odometer reads over 12,000. Chrysler Corp. Has been involved since Jan 2015 but refuse to allow me to speak with anyone with authority to discuss lemon laws. Say no such department exists. It goes back in mon. 2-16-15 for yet another round of repairs.

- Whitehall, MT, USA

While towing a travel trailer, accelerator was applied to allow me to pass some slow semi's. there was no response from the accelerator as I held it down for about 10 seconds. Exhaust brake engaged!! it wasnt even on!! however, I had the cruise control on but not engaged. I quickly engaged the resume feature and used the accelerate function of the cruise control to speed up to avoid an accident. This has happened on multiple occasions but this by far the scariest. Also the exhaust brake engages when not even on at random coasting times when not hauling anything. It is very dangerous to not be able to control a big truck due to these glitches. Also two of these Firestone tires have worn bald at 18000 miles. Accelerator has no response when a quick stop and go transition is applied.

- Phoenix, AZ, USA

I lowered passenger rear window. Air came in I all most lost control of my truck..passenger front seat vibe rated so bad it came lose from floor.. Dodge garage said this is not their problem.. people need to know about this problem..

- Cape Coral , FL, USA

The contact owns a 2014 Dodge Ram promaster 2500. The contact stated that while decelerating, the brakes emitted an extremely loud noise. The vehicle was taken to the dealer where the failure could not be diagnosed. The vehicle was not repaired. The manufacturer was contacted about the failure. The failure mileage was 94.

- Silver Spring, MD, USA