9.4
really awful- Crashes / Fires:
- 0 / 0
- Injuries / Deaths:
- 0 / 0
- Average Mileage:
- 1,350 miles
About These NHTSA Complaints:
The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.
Hydraulic control unit was replaced July 2020 (ABS traction control lights coming on MEANING, NO ABS NO TRACTION NO 4 WHEEL DRIVE.) Hydraulic control Unit not working AGAIN. I have NO ABS, NO TRACTION, NO 4 WHEEL DRIVE, AGAIN. CHIME GOING OF CONSTANTLY AND DEALERSHIP HAS HAD "PART ON ORDER SINCE JAN 2023"
- Brooksville, FL, USA
The 2019 travato was built on this Ram 2500 chassis. Winnebago glued heavy, silver aluminum trim strips to the bottom of all sections of this van. We had the one on the driver's door fall off while parked in las vegas in March of 2019. We had this reattached which was covered by warranty. In November of 2019 we discovered over eight more sections coming loose and it was going to cost $1,300 to have them reinstalled. We were told that there was no guarantee that we would not have to have them reinstalled 4 or 5 years later. We elected to have them removed instead. These are heavy pieces of metal that are exposed to high wind gusts while travelling at highway speeds. If one (or more) should fly off while in transit, they could damage vehicles following us or even cause a fatal accident.
- Vancouver, WA, USA
The contact owns a 2018 Ram 2500. The contact took the vehicle to H and M motor company (373 E 3rd St, weston, wv 26452, 304-269-5727) for routine maintenance. The dealer informed the contact that the vehicle was included in NHTSA campaign number: 19V021000 (steering) and performed the recall repair. After the recall repair was performed, the contact took the vehicle to an independent mechanic to have the tires replaced and for an alignment. The mechanic informed him that due to the welding that was performed during the recall repair, they were unable to perform an alignment. The same dealer was contacted and informed him that the work they performed on the vehicle was approved by the manufacturer. The manufacturer was notified and the contact requested that they pay for the alignment due to the work performed on the vehicle. The manufacturer denied the request and provided case number: 64758281. The vehicle had not been repaired. The contact had not experienced a failure.
- Weston, WV, USA
- Alpine, AL, USA