Hi, In my car VSC light is always on, I got it scan as well but it doesn't show any code for VSC and ABS systems. Toyota dealership also don't give any information about the codes. It's kind of very dangerous to drive with all the lights on the cluster. Thank You

- Shelton, CT, USA

I was driving my car when suddenly the speedometer started going from 0-60 back and forth, the rpms was all over the place, the brake light came on and stayed on and the lights was going from bright to dim, there was a couple more lights aluminized on my dash. After googling the problem that nearly caused me and my children to crash, there is so many people affected by this same problem in the 2007 toyota camry. Why hasn't this been recalled or class auctioned. Also my dash board is sticky like tar.

- Richmond, KY, USA

Error code C1391 Multiple warning lights like VSC, brakes, check engine, hybrid system failure. Vehicle has been repaired at Dublin Toyota dealership under recall several years ago and the vehicle has failed again with the same fault.

- Tracy, CA, USA

The ABS brake actuator, part 44510-30270, initially failed in January of 2021 while traveling on the highway from Los Angeles to San Francisco. The VSC (vehicle stability control system) message appeared accompanied by multiple warning lights, followed by severely limited braking ability which endangered my family during high speed traffic on the 5 freeway. I purchased a used actuator on eBay immediately, it lasted not quite 2 years (it's 2023), it has now failed. I recently purchased a new used actuator pump again, and it has failed immediately. There is obviously a design flaw with this part, yet YOU (NHTSA) and Toyota refuse to address it properly. There is no reason why this device has not been recalled other than negligence. You need to reopen this case, and force Toyota to recall this part before someone is injured or worse!

- Spring, TX, USA

My ABS isn-??t working properly prohibiting me to drive safely. The ABS module had a recall but it had yet to be repaired and replaced. I need help. Thank you!

- Tallahassee, FL, USA

I was driving on a residential street and my brake pedal got stiff and then got soft and I couldn't stop. I pushed the pedal hard and almost hit the car in front of me and then I felt a hard clack and it felt like I was hit or like I hit something. A loud high pitched beep continuously sounded until I turned off the car. All of my dashboard lights came on. And a continuous winding sound is coming from the abs pump.

- Chula Vista, CA, USA

ABS Brake Actuator failed, this malfunction came out of nowhere, making me unable to stop my car and putting my life at risk. I have not seen any official recall on this from Toyota, but I-??ve seen many people have this same specific issues on Toyota forums. The ABS, brake, and slip light came on all at once while my car made a continuous beeping sound. This all happened as my brakes went out.

- Atlanta, GA, USA

Had the vehicle progressively speed up at a high rate of speed was not due to the floor mats as that had been fixed along time ago on a recall before. I had to throw the car in neutral and then push the brake and power button for the vehicle to slow down safely ( happened twice ). Both times not back to back on occasions months in between. Then one day had issues with the brakes and the vehicle not wanting to stop had the issue looked at by certified mechanic said my physical brakes on all sides front and back were visible sound and nothing to be causing the issue I was having. Just the other day started the vehicle as normal it warmed up went thru my day and then my radio still visible but sayin INSERT MAPS DVD ( that-??s the only thing it would say or do ) then the vehicle after turning it off says CHECK VSC SYSTEM ( had certified mechanic ) come to home to inspect vehicle for issues ( car no longer showed this on dash) started as normal then next day while driving no brakes red triangle of death came up said CHECK VSC again and brakes failed and I nearly rear ended someone thank god avoided the accident car then shut off ( car restarted then triangle once more immediately shut off ) car starts high idle brakes hard to push on Mechanic says it-??s a faulty issue with harness or abs pump and ECM components which may be causing the battery failure I-??ve had multiple times and that the vehicle isn-??t safe to drive due to this issue.

- Selah , WA, USA

Dash cluster showed brake light and BAS light on, tachometer and speedometer dropped to zero while going approx. 40 MPH.

- Sarasota, FL, USA

On the dashboard there is -??check VSC system-?? and then the ABS and brake symbols. Took it at the Toyota dealer for a diagnostic and said brake actuator needed to be replaced.

- Downey,, CA, USA

when driving both of ABS & Break dashboard warning lights are on, RPM meter will go up & down, temperature gage is down. Unable to be certain the vehicle safe to be operation.

- Rowland Heights, CA, USA

My abs pump failed causing my brakes to lock up and totaled my car

- Deville, LA, USA

My brake pedal when depressed, when stopped, makes a loud noise. My car cycles a buzzing sound often, even when the brakes are not depressed. My warning lights : check VSC system, ABS, warning triangle, a circle with and exclamation point and brake, all are continuing to light up on my dash. I took it to the dealer. Code C1391 (ABS ACRTUATOR INTERNAL FAILURE). This is serious and can cause my brakes and steering control to fail. The manufacturer warranty has expired.

- Charlotte , NC, USA

Was driving an it made a noise then the brake light abs light an vcs light came on at the same time an I see on here where some people have the same problem with the same car so what do I need to do about

- Williamson , WV, USA

Abs module is making a lot of noise at all time while vehicle is on and now it-??s harder to brake abs modules is failing.

- Antioch, CA, USA

brake pedal is hard to press, speed odmeter does not work, safty belt warraning light does not work, ABS dash light stays on.

- Quapaw, OK, USA

My car has a mileage of about 178K and just recently got a "Check VSC System" which apparently affects brakes and also manages stability in case of hazardous road conditions. Across the internet, people also have reported the same issue and in some cases, people have had brakes locking up once this warning came up. Per a recall from Toyota, this is being fixed by the manufacturer only within a certain date and mileage and I dont fall into either of these criteria. The part itself is very expensive to afford right now...would be appreciative if the manufacturer can provide a way to fix this for a nominal cost or for free. Recall notices: https://testing-public.carmd.com/Tsb/Download/104574/T-CP-ZE1-A110-D

- Yorba Linda, CA, USA

I had a rollover accident in my Camry on 5/13/2021. My brakes locked up which sent me into a spin and then eventually flipping over an embankment. Only one of my airbags deployed and it was the passenger door airbag. The rest of the airbags did not go off. Yes the vehicle is still available for inspection. My safety was put at risk because of the brake malfunction and subsequently because of the airbags not deploying in the manner they are aupoosed to. I rolled the vehicle I'm sure the manner in which h I wrecked would have caused all airbags to deploy. No I never seen a brake or a airbag light on my dashboard. No one else has inspected the vehicle components other than an insurance claims rep to determine my vehicle is a total loss. I'm unsure on who I could have look at it without compromising the integrity of the findings. The brakes however were worked on by jd byrider a week and a half before the accident. They changed my rotors.

- Charleston, WV, USA

Vsc check system is on at all times and my car doesn't start at all.

- Plantation, FL, USA

Car has abc light on vsc system warning light, hard break, break stop working noise sound. Replaced in 2014 and now defective again

- Wichita, KS, USA