7.9
pretty bad- Crashes / Fires:
- 0 / 0
- Injuries / Deaths:
- 0 / 0
- Average Mileage:
- 5,444 miles
About These NHTSA Complaints:
The NHTSA is the US gov't agency tasked with vehicle safety. Complaints can be spread across multiple & redundant categories, & are not organized by problem. See the Back button — blue bar at the very top of the page — to explore more.
Horn is hard to blow. Rear end makes whining noise and it started using 5 quarts of oil between oil changes. I only have 36000 miles on it. They replaced manifold intake gasket at my expense. The fuel gauge does not work right. Luckily I didn't ruin the engine that I know of. I understand there have been a lot of problems with intake gaskets. How long does it take to get a recall on defective parts?
- King, NC, USA
Consumer was having problems with the intake manifold. The intake manifold ruptured which caused the oil to be sucked out of the oil pan, after the repair was made on the gasket, the bearing on the crankshaft failed, prior to the failure the consumer noticed the oil pressure gauge did not register correctly.
- Alsip, IL, USA
The engine consumed six quarts of oil in the last 3000 miles. The dealer was notified and indicated that there was nothing they could do since the vehicle was no longer under warranty.
- San Diego, CA, USA
Oil changes were done every 3000-5000 miles. The third and fourth piston rods were worn down and then broke. ******dims 11 IVOQ entry posted after 12/12/02 cut-over to artemis*****7757169
- Tucson, AZ, USA
Consumer states while driving at highway speed the engine will shut down causing lost of power steering. Please provide any additional information.
- Bangor, ME, USA
The head gasket has cracked and causing oil to burn prematurely.the dealer has been notified.
- Cohasset, MA, USA
Engine blew a rod, causing engine to rattle.
- Bonnie Terre, MO, USA
#4 cylinder head cracked, but head gasket worn on other head as well so we chose to replace both heads. We reported to Chrysler and they agreed to pay half the cost to replace the two heads including labor.
- South Windsor, CT, USA
Engine piston seals were never seated properly which allowed engine to operate erratically. While driving at approximately 70 mph, engine locked up, and consumer had vehicle towed. A private mechanic replaced engine. Please provide any additional information/attachments.
- Bruceville, TX, USA
Head gasket is leaking onto exhaust. The oil leaking on to the exhaust pipe could cause fire when the exhaust pipe becomes hot.
- Joliet, IL, USA
When driving the plenum within the engine head gasket blew out. This part has blowen out every 6 thousand miles, parts have been replaced on three different occasions.
- Miami, FL, USA
Leaking oil through tailpipe-engine clatter at high speed. Defective intake base gasket. Blew out four quarts of oil over 750 mile trip, mostly interstate travel. Service bulletin not divulged to owner during routine service.
- Biloxi, MS, USA
Failure of the intake gasket caused the engine's oil supply to be evacuated through the vacuum system. Not only was this event detrimental to the engine itself but it also contaminated the vacuum and exhaust systems.
- Mexico, NY, USA
Truck vibrates between 30-67 mph. Dealer has changed the torque converter, drivershaft, replaced ring and pinion, yoke, bearings and seals. Truck has burned 1/2 qt of oil per 1000 miles since new.
- Hebron, IN, USA
Vehicle consumes large volumes of oil in short periods. Also, the vehicle vibrates in the steering column area, cause unknown. Vehicle vibrates allover at speeds between 35-65 mph now. Vibration started 45-55 mph when new.
- Hebron, IN, USA
- Unknown, DC, USA