The contact owns a 2000 Dodge Ram 1500. While pulling out of the driveway, the contact noticed that the brakes felt low. He also noticed that the brake hose assembly was leaking brake fluid from the front brakes. The VIN was not included in NHTSA campaign id number 01V038000 (service brakes, hydraulic foundation components: Hoses, lines piping, and fittings); therefore, they would not assist with the repair. The vehicle is currently parked at the contact's residence. The failure and current mileages were 70,089. Updated 04-17-09 updated 04/20/09.

- Danielson, CT, USA

While driving my 2000 Dodge truck the main brake line ruptured without warning. I could not stop the vehicle and successfully attempted to do so with my emergency brakes.

- Evans, GA, USA

The consumer recieved recall notice 01V-038, the consumer attempted to have it repaired on several occasions, the notice states that the work would take about one hour to complete but it took the dealer 8 hours, the front brake pads were replaced. Nlm

- Vallejo, CA, USA

The consumer recieved recall notice 01V-038, the consumer attempted to have it repaired on several occasions, the notice states that the work would take about one hour to complete but it took the dealer 8 hours, the front brake pads were replaced. Nlm

- Vallejo, CA, USA

On three occasions the consumer took the vehicle to have recall 01V-038 for the front brake hose and sensor, but the part was not available (once) or the wrong parts were recieved (twice).

- Tucson, AZ, USA

Consumer received recall 01V-038 and informed dealer that repairs needed to be complete due to the brake line was rubbing against a tire, vehicle was taken to dealer for recall repairs and dealer stated repairs were complete, however consumer checked and found that nothing had been done, the service manager stated that they did not see leaking fluid and therefore thought that it was okay, consumer is finally getting repairs complete.

- Austin, TX, USA

Brake line on rear drivers side of the vehicle rubs against a rod in vehicle, causing a hole, 3/16th of an inch deep, to form in brake line. Dealer tied brake line to vehicle so that line would not rub against rod. Please provide any additional information/attachments.

- Kalispell, MT, USA