The contact owns a 2011 Toyota Tundra. The contact stated that upon loading the bed of the truck, a worker stepped on the bed and his foot went through the bed. There was no injury sustained. The contact then noticed that there were four 3-inch holes located near the bed bolts of the vehicle due to corrosion. Additionally, the contact stated that the frame was corroded. The contact related the failure to TSB Number: [XXX]. The contact stated that he was an independent mechanic and had determined that the failure occurred because there was no underbody coating on the vehicle, which caused water to be trapped on the underbody. The local dealer was contacted, but no assistance was provided. Another dealer, Oakbrook Toyota (550 E Ogden Ave, Westmont, IL 60559), was notified of the failure and referred the contact to the NHTSA Hotline for assistance. The vehicle was not repaired. The manufacturer was notified of the failure and informed the contact that they could not assist because the VIN was not included in a recall. The failure mileage was approximately 68,000. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

- Addison, IL, USA

The contact owns a 2011 Toyota Tundra. The contact stated that the truck bed bolts that secured the truck bed to the subframe were rusted. The vehicle was taken to the dealer however, the contact was informed that the VIN was not under recall relating the failure. No additional assistance was provided. The manufacturer was contacted and notified of the failure. The failure mileage was 104,000.

- Easton, MD, USA